Decking blocks for temporary event installations: setting up a removable platform

For a temporary event installation, the platform must often be set up within a short timeframe and then dismantled without compromising the site’s future use. Whether for outdoor trade shows, reception areas, or temporary installations, each project requires an assessment of the subgrade, loads, levels, and traffic conditions.

Buzon adjustable pedestals can be configured to create a removable floor on a suitable base. For event agencies, set designers, engineering firms, and installation companies, the benefit lies in the ability to adjust the supports and plan for dismantling right from the design phase. However, their use must be validated for the intended structure and purpose: a floor intended for public use cannot be designed based solely on the choice of pedestals.

Dry installation, provided the substrate is suitable

Pedestal installation does not, in itself, require a screed to be poured or each pedestal to be fixed to the substrate. It may therefore suit sites where permanent work must be limited. Dismantling the platform can also be planned from the outset.

This does, however, require a stable substrate with sufficient load-bearing capacity that is compatible with the support points. A concrete slab or existing surface must not be used without assessing its condition and the loads it will need to support. On natural ground, grass or soft soil, pedestals must not be installed directly without appropriate preparation: settlement and changes in ground conditions could compromise the stability of the assembly.

Where a load-spreading base or intermediate platform is considered, it must be designed as part of the complete system. Dry installation alone does not guarantee that a finished surface will remain free of marks or damage: protective measures and a condition survey may be necessary, depending on the site.

A modular solution with potential for reuse

In the events sector, the ability to reuse installation components can be as important as installation speed. Buzon pedestals can be removed, inspected and reused on another project, provided their condition and compatibility with the new configuration allow it.

Their height adjustment helps set the support points to the required finished level. To make this flexibility useful to technical teams, the layout, required pedestal models, installation procedure and storage arrangements after dismantling should be planned from the design stage.

Reuse can reduce purchases of new components and waste associated with some installations. Its environmental benefit nevertheless depends on the number of times the components are reused, transport and the other materials making up the platform; it cannot be quantified without assessing the project.

Correcting a slope within the system’s limits

Where the load-bearing base is sloped, the U-PH5 slope corrector can be used with pedestals in compatible configurations. Placed beneath the pedestal, it can correct a substrate slope of up to 5%, in accordance with the specifications of the selected system.

This correction must be distinguished from ground stability. The U-PH5 adapts the pedestal’s bearing surface to a sloping, load-bearing substrate; it does not make soft ground suitable for an event platform. The finished platform level, connections to circulation routes and water drainage must be planned separately.

Before installation, a level survey makes it possible to check that the pedestals’ adjustment range and the available height are suitable for the site.

Loads and safety: designing the complete installation

A temporary platform may be subjected to very different demands depending on whether it accommodates staff, the public, furniture or equipment. The design must cover the entire installation: existing substrate, pedestals, substructure, surface finish, connections and edge details.

Imposed loads, pedestrian movement, wind effects on associated structures and evacuation arrangements must be assessed according to the type of event. Tents, stages and temporary grandstands require a specific assessment: their loads and anchoring systems must not be assumed to be compatible with a pedestal terrace.

For areas open to the public, requirements concerning stability, safe circulation and accessibility must be defined with the project’s technical managers and in accordance with the rules applicable to the site.

Buzon pedestals can therefore contribute to dismantlable and adaptable event platforms, provided the substrate and complete system have been assessed. Their value for a temporary project depends on careful preparation: selecting a suitable base, designing the platform for its actual use and planning both installation and dismantling.