Correcting a slope within the system’s limits
Where the load-bearing base is sloped, the U-PH5 slope corrector can be used with pedestals in compatible configurations. Placed beneath the pedestal, it can correct a substrate slope of up to 5%, in accordance with the specifications of the selected system.
This correction must be distinguished from ground stability. The U-PH5 adapts the pedestal’s bearing surface to a sloping, load-bearing substrate; it does not make soft ground suitable for an event platform. The finished platform level, connections to circulation routes and water drainage must be planned separately.
Before installation, a level survey makes it possible to check that the pedestals’ adjustment range and the available height are suitable for the site.
Loads and safety: designing the complete installation
A temporary platform may be subjected to very different demands depending on whether it accommodates staff, the public, furniture or equipment. The design must cover the entire installation: existing substrate, pedestals, substructure, surface finish, connections and edge details.
Imposed loads, pedestrian movement, wind effects on associated structures and evacuation arrangements must be assessed according to the type of event. Tents, stages and temporary grandstands require a specific assessment: their loads and anchoring systems must not be assumed to be compatible with a pedestal terrace.
For areas open to the public, requirements concerning stability, safe circulation and accessibility must be defined with the project’s technical managers and in accordance with the rules applicable to the site.
Buzon pedestals can therefore contribute to dismantlable and adaptable event platforms, provided the substrate and complete system have been assessed. Their value for a temporary project depends on careful preparation: selecting a suitable base, designing the platform for its actual use and planning both installation and dismantling.